Briefly Describe The Tips For Using Diamond Blades
Diamond blades have a lot of tips when using them, they can help us better use diamond blades, and let's show us the techniques for using diamond blades.
1, Idling: especially when the new substrate is first used, it needs to be idled for about 30 minutes, summer high temperature season also needs to take water idling, the purpose is to further eliminate the welding head on the base, and enhance the blade in the high-speed rotation state to maintain the quality of the connotation of memory.
2, Waste material should not be less than 0.5m3, and placed securely, the bottom surface should be padded with square wood, stuffed solid, waste material should be located in the symmetrical position of the workbench, to ensure the stability of the workbench and waste material, there must be no shaking, trembling phenomenon.
3, Diamond saw blade use tips, according to the length, width, high adjustment of the travel switch of the waste material, so that the blade lift and the travel of the truck in a solid and useful range. Saw cutting before saw blade blade should be 10 to 20mm high from the pioneer zui. After sawing, sawing from the bottom of the waste should be left 20-40mm, saw blade blade around the run, should make the blade all exit the waste saw, the interval should not be less than 150-200mm, to prevent the blade impact waste.
4, Saw blade empty and secure before the test cutting, prohibit saw blade blade and waste touch when starting saw blade, cutting stop saw blade rolling, must exit the saw before stopping.
5, Cutting if found that the waste material has shaking should immediately stop cutting, to be fixed after the waste material firmly can continue to work, cutting, prohibit arbitrary movement of waste material.
6, Cutting found that the saw blade has a significant deceleration or even clip the phenomenon, it may be belt slip, pressure nut loose or eat knife depth is too large, knife speed too fast and other reasons, should be adjusted in time.
7, Line speed should be in line with the hardness and wear resistance of processed stone, it is recommended to select the following line speed cutting different types of stone.
8, Diamond saw blade use techniques, into the knife speed, mainly depends on the function of processing materials, each material when the depth of a certain size of the knife speed, if the speed is too high, it will make diamond accelerated wear or even fall off, the formation of saw blade consumption too fast, if the speed is too low, it will make the saw blade self-sharp process can not be carried out normally, so as to "grind, slip" lost cutting talent. In general, feed speed in the cut-in to be slow, in sawing should be uniform, about the common typical material, when the depth of 20mm, recommended the following feed speedometer for you to see, when the thickness changes, the cutting speed can be converted by cutting area (cm2/min).
