Points For Attention When Cutting Metal Saw Blade

The cold saw metal circular saw blade needs to be adjusted and set when cutting. Some operations in details can effectively improve the cutting effect and extend the service life of the cold saw metal circular saw blade, including the stability during cutting and the quality of the workpiece.

1, Preliminary preparation When using the cold saw metal circular saw blade, it is necessary to do the preparatory work in the early stage, especially the saw blade device. It is necessary to preheat idling before operation. The so-called preheat idling refers to the operation of the cold saw metal circular saw blade for a period of time after the device is installed and before operation (no need to cut any information, just empty operation), which lasts about 1 minute to 10 minutes (details need to be determined according to the actual situation). In case of hot weather, it also needs spray mist or water; This is helpful to enhance the cutting edge of the saw blade. If the device is just installed, the cutting operation can be carried out directly, and the damage of the metal circular saw blade can be easily formed.

2, Some precautions in sawing It is necessary to pay attention to some problems in the sawing process of cold saw metal circular saw blade. If we do not work carelessly, it may bring permanent damage to the equipment and saw blade.

1. After idling, check the distance between the cold saw metal circular saw blade and the cutting data (commonly known as the saw blade to zero), and do not start the operation when the saw blade contacts the data.

2. If it is found that the data is shaking during the cutting process, it is necessary to stop the operation and check the fault side by side before the cutting operation can be carried out again (during the operation, do not move the data and do not touch the saw blade with hands).

3. In the process of cutting, if it is found that the metal circular saw blade of cold sawing has slight shaking or teeth clamping behavior, it is necessary to stop the equipment immediately. It is very likely that it is caused by the clamping of a certain part or the problem of magnetic powder clutch.

4. If in sawing, it is found that there are problems such as deceleration or cutting quality decline, the operation should be stopped, check the nut or the feed depth is too large, the operation speed is too fast, and check and adjust in time. It is necessary to check the important parts carefully when using cold saw metal circular saw blade to cut.