Knowledge

Three wear and tear damage affecting diamond saw blades

Diamond saw blade in the process of cutting the stone, will be centrifugal force, sawing force, sawing heat and other alternation load effect. The wear and tear of diamond saw blades is caused by force and temperature effects.

(1) Force effect: In the sawing process, the saw blade is subjected to the effect of axial force and tangential force. Because of the effect of the force in the circular direction and radial presence, the saw blade is wavy in the axial direction and in radial shape. Both types of deformation will cause uneven rock cutting surface, stone waste, sawing noise, vibration, resulting in early diamond block breakage, saw blade life reduced.

(2) Temperature effect: the traditional theory holds that the influence of temperature on the saw blade process is mainly manifested in two aspects: one is to cause diamond graphiteization in the clumps, and the other is to cause the thermal force of diamond and fetal body to cause premature drop of diamond particles. The new study shows that the heat that occurs during the cutting process is mainly passed into the clumps. The temperature of the arc area is not high, usually between 40 and 120 degrees C. However, the grinding point temperature is higher, generally between 250 and 700 degrees C. The coolant only lowers the average temperature of the arc area, but has less effect on the grinding particle temperature. Such a temperature does not cause graphite carbonization, but will cause the conflict between the mill and the workpiece performance changes, and the diamond and additives between the thermal stress, resulting in a fundamental bending of the diamond failure mechanism. The study indicates that the temperature effect is the influence factor that breaks the saw blade.

(3) wear breakage: because of force effect and temperature should be, saw blade through a period of time of use will often occur wear breakage. The forms of wear and tear are as follows: abrasive wear, partial crushing, large area crushing, drop, combined agent along the direction of sawing speed mechanical abrasion. Abrasive wear: diamond particles and parts constantly conflict, edge passivation into a plane, lost cutting performance, increase the conflict. Saw cutting heat will make the diamond particle appearance graphite thin layer, hardness is greatly reduced, increased wear: diamond particle appearance to accept the heat stress of cross-transformation, but also accept the cross-cutting stress, there will be tired cracks and partially broken, showing sharp new edges, is a more ideal form of wear; Drop: The alternating cutting force causes the diamond particles to be shaken continuously in the binding agent and loosened. At the same time, the binding agent itself in the sawing process wear and sawing heat to soften the binding agent. This causes the binding agent's grip force to decrease, and when the cutting force on the particles is greater than the holding force, the diamond particles will drop. Either type of wear is closely related to the load and temperature accepted by the diamond particles. Both depend on the cutting process and cooling smooth conditions.


You Might Also Like

Send Inquiry