Knowledge

Why granite saw blades are smoothed?

1, saw blade idling: special new substrate first use, need to idle 10-20 minutes or so, summer high temperature season also need to take water idling, the intention is to further eliminate the welding head on the base, and enhance the saw blade in the high-speed rotation state to maintain the internal quality of memory.

2, cutting waste material shall not be less than 0.5m3, and placed securely, the bottom surface should be cushioned with square wood, stuffed solid, waste material should sit on the symmetrical position of the workbench, to ensure that the workbench and waste material is stable, there must be no shaking, shaking phenomenon.

3, according to the length, width, height of the waste material adjustment travel switch, so that the blade lift and the travel of the truck in a reliable and effective range. Saw cutting before saw blade blade should leave the waste material zui height 10 to 20mm. After sawing, sawing from the bottom of the waste should be left 20-40mm, saw blade blade around the run, should make the blade all exit the waste saw, the interval should not be less than 150-200mm, to prevent the blade from hitting the waste material.

4, saw blade empty turn secure before the test cutting, prohibit saw blade blade and waste material contact when starting saw blade, cutting stop saw blade rolling, must exit the saw before stopping.

5, cutting if found that the waste material has shaking should immediately stop cutting, to be fixed solid waste before continuing to work, cutting, prohibited arbitrary movement of waste material.

6, cutting found that the blade has a significant deceleration and even clip knife phenomenon, it may be belt slip, pressure nut loose or eat knife depth is too large, knife speed too fast and other reasons, should be adjusted in time.

7, line speed should be adapted to the hardness and wear resistance of processed stone, because there are many varieties of granite, the corresponding hardness will be different, if a single stone is soft, to inform their saw blade suppliers you cut stone varieties, let them provide the corresponding partial wear-resistant blade, on the contrary, if it is hard granite, you need sharp cutting sheet. And if you cut a wide variety of stone, you need to correspond to the universal saw blade (tip: online speed is not high, add cutting power, will reduce the life of the blade. )


You Might Also Like

Send Inquiry