How to edge ( guide for edging )

1.Most of diamond segments are sintered in the mold,and the maximum of segment No. in the same mold is not more than16. While there are tens of, even hundreds of, segments on a single blade. This explains why the different sizes of segments from the same blade occurred. And this is also the answer for why the new blade should be edged/openned before putting into use.

2.The new segments just produced are enwrapped by the metal bond matrix, should be edged/openned before putting into sawing.

3.It is recommended to edge/open blades on the edger/open machine before installed on the saw machine, this is in consideration of the edging/openning efficiency and the quality to the blade.

4.For the installed blades, apply firebrick or softs and stone for the edging/openning before putting blades into work.
 
5. It is also recommended to use firebrick(and so on)to restore the edging/openning of the blade which become blunt.