How do we maintain the Diamond blade?
The Diamond blade is an indispensable tool for stone processing. There are many kinds of Diamond saw blade in the market. Sometimes, the lifespan does not depend entirely on its quality, if it has not been used in time,or in the use of the process, or even it is not timely maintenance. At the same time, it also need users to treat them attentively, thus extending their life, and help you save more costs.
Maintenance methods of Diamond Saw Blade:
1. If the Diamond saw blade is not used immediately, it should be placed flat or hung up by an inner hole.Do not pile up any other objects or step on the flat Diamond saw blade, and pay attention to moisture resistance and corrosion resistance.
2. When the Diamond saw blade is no longer sharp and the cutting surface is rough, regrinding must be carried out in time. It shouldn’t change the angle or break the dynamic balance while regrinding.
3. It must be performed by the manufacturer when you correct the internal diameter and machining the pin hole of Diamond saw blade. If the processing is not good, it will affect the use of the product, and may be dangerous. In principle,enlarging the diameter of the hole can not exceed the original aperture 20 mm, so as not to affect the balance of tension.
Diamond Blade's using Requirements:
1.Before cut, the workpiece should be fixed, the profile should be positioned in the direction of cutting, to avoid abnormal cut, side pressure or curve cutting. The cutting should be smooth, avoid sudden contacting. For this may lead to damage to the saw blade, or the workpiece flying out, causing an accident.
2. When the abnormal sound and vibration, rough cutting surface, or strange smell are found, the operation must be terminated immediately, then timely inspection, troubleshooting to avoid accidents.
3. At the beginning of cutting, do not feed too fast, to avoid causing broken teeth and damage.
4.Please do not cut for a long time if dry cutting, so as not to affect the lifespan of the saw blade and cutting effect. When wet cutting, should add water to cut, guarding against electricity leakage.
